GE Industrial Solutions Neutral Mounting Kit - DNK400 - Manual

g
DEH44151 Installation Instructions
Neutral mounting kit
1
Catalog number – TNK400
Introduction
This bulletin provides instructions for
installing Neutral lug kit – TNK400 on all
GE Double throw safety switch rated
400A.
WARNING: Hazard of electrical shock or
burn. Turn off power before working
inside this equipment.
Description
This neutral kit consists of the following
parts:
1. One (1) Neutral assembly
2. Two (2) 1/4-20 X 9/16” mounting
screws
Mounting Instruction
1. Tighten item 2 (Mounting screws) in to
mounting hole in the enclosure. Ref. Fig 1
2. For bonding, bare wire 1/0 CU/AL is to
be used to connect small lug in neutral
assembly to ground kit (Order
separately).
Wire range: 2 – 600MCM CU/AL
Fig 1
g
These instructions do not purport to cover all details or variations in equipment nor to provide
for every possible contingency to be met in connection with installation operation or
maintenance. Should further information be desired or should particular problems arise which
are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the GE
Company.
General Electric Company
41 Woodford Ave., Plainville, CT. 06062
GE Consumer & Industrial
DEH44151 R01 08/07 © 2007 General Electric
Visit us on the web at www.GEindustrial.com