GE Industrial Solutions WattStation Wall Mount Hardwired Version - Manual (Page 2)

Step 4: Remove the oval snap-fit ring to access the cover
hardware. Take off front cover and the deadfront shield.
GE Energy
41 Woodford Avenue
Plainville, CT 06062
www.geindustrial.com
© 2011 GE Company
imagination at work
DET-752 (07/11)
STEP 5 and Step 6 (HW)
STEP 4 (HW)
STEP 4 (HW)
Continued
Snap-fit Ring
Cover
Deadfront
Shield
WattStation
Step 5: Remove the wire pigtail from the line side
of field wiring block and discard.
Step 6: Feed the supply power and ground wires through
WattStation enclosure holes. Slide WattStation onto the
mounting bracket, ensuring that the opening in the back
plate bracket aligns with the tab on the wall mount bracket
Step 7: Connect supply power wires to line side of fuse block
and ground wire to the ground bar
Step 8: Replace the deadfront shield, the front cover with
the provided hardware and the oval snap-fit ring.
WattStation TM is a trademark of General Electric Company.