GE Industrial Solutions AKD-5, AKD-6, and AKD-8 - Manual (Page 11)

10 Retrofill Doors Assemblies for AKD-5, AKD-6, and AKD-8 DEH-41563 02/12
Replace AKD5 Door
Sequence of replacement of door assemblies will remain the same for all AKD5 type doors.
1. De-energize/switch off the LVS section that is to be retrofitted.
2. Open the compartment door that is to be retrofitted.
3. Rack out the existing legacy AK/AKR breaker from the LVS.
4. Keep the door open for accessing the door mounting hinges. These are placed on the right side wall of the
moving frame in the LVS compartment.
5. The door hinge is mounted via 2/3-mounting pins that hold the door in place.
6. Lift the pin out of the hinge joint. This allows access for removing the old door from the LVS compartment.
7. Unpack the new door assembly and mount it on the door mounting hinges. These are located at the right
side of the moving frame.
8. Replace the hinge pins and secure the joints.
9. Insert the new retrofitted EntelliGuard R Retrofill circuit breaker into the compartment and slide the breaker into
the disconnected condition.
10. Close the new door and secure it to the compartment.
11. Rack-in the new retrofitted EntelliGuard R Retrofill in.
Modify Existing Door
If customer doesn’t want to buy a new door, the customer can modify the existing door:
1. Remove the legacy door assembly from the LVS section.
2. Modify the door cut out as per the new door cutout template.
3. Check the through-door racking with the new door assembly.
AKD-6, AKR Retrofit Door
Retrofit doors for the can be ordered as required, depending on door size and if you want door cutouts for accom-
modating lamps and ammeters.
Table 3 lets you select a specific door type ( Figure 9 and Figure 10). In this section,
the particular wireframe figures different door sizes. It can be ordered by catalog number by referring to the last
column in the table. Some doors allow cutouts for lamps and/or ammeters; some do not. All the doors in
Table 3 are
right-hand doors.