GE Industrial Solutions EntelliGuard G Bell Alarm W_ Lock-out - Manual (Page 2)

Figure 1. (A) Front Cover (B) ScrewRemoval (C) Handle
Rotation
4. Remove the trip unit from the PMU base.
5. While holding the switch lever, slide the bell
alarm contact assembly on the PMU base as
shown in Fig. 2.
Figure 2: Assembly of Bell alarm
6. Assemble the 4 screws as shown in Fig. 3.
Figure 3: Fixing the screws
7. Using a wire tie, tie the wires on the PMU base
wall as shown in Fig. 4.
Figure 4. Assembling wire tie
8. Connect the input wire assembly plugs to the
terminals A33, A34 & A35 locations marked on
the secondary disconnect block A as shown in
Fig. 5.
Figure 5. Assembly of connectors
9. Assemble the Trip Unit back.
10
. Rotate the charging handle down and slide
the front cover over the handle to assemble the
front cover to housing as shown in Fig. 6.
2