GE Industrial Solutions Time Delay Module User Manual
Page 2
Fig 1: Mounting holes location
dimensions are in mm (Inches)
6. Assemble the TDM module with two M4 screws
as shown in the fig 2.
(3.13)
(2.74)
Figure 2. TDM mounting
7. Alternatively TDM can be mounted on a din rail
as shown in the fig 3.
Figure 3. Din rail mounting
These instructions do not purport to cover all details or variations in equipment nor, to provide contingency to be met in connection
with installation, operation, or maintenance. Should further information be desired, or should particular problems arise which are not
covered sufficiently for the purchaser’s purposes, the matter should be referred to GE.
GE
41 Woodford Ave, Plainville, CT 06062
www.geelectrical.com
© 2009 General Electric Company
DEH-41406 R1 (03/09)
2