GE Industrial Solutions Control System Toolbox For Configuring the Trend Recorder - Manual (Page 15)

GEH-6408A Trend Recorder Chapter 2 Trend Recorder Window
•
7
Move Signal Up/Down also
changes the position of the
signal in stacked view.
Set Signal As Trigger specifies the selected signal as the trigger for real-time
triggered mode trends.
Move Signal Up moves the signal up one position in the Signal View.
Move Signal Down moves the signal down one position in the Signal View.
Set As X Axis marks the chosen signals to be the X-axis for X-Y plots.
Edit Block invokes a detached block diagram view in a block-collected trend.
View Menu
The View menu allows you to view areas of the Trend Recorder as follows:
Toolbar controls whether the Trend Recorder toolbar displays.
Status Bar controls whether the Trend Recorder status bar displays.
Stacked Traces controls whether the Trend Recorder displays each signal trace in
its own window (stacked mode) or in one signal graph view.
X-Y Plot Mode controls whether the X-axis of the Trend Recorder is based on the
value of one of the signals that has been collected (X-Y plot mode) or based on time
(normal mode).
Power Spectrum shows a spectral analysis of the trended data using a Fast Fourier
Transform.
Upload Data causes the data collected by the collector block of a block-collected
trend to be uploaded to the Trend Recorder.
Record starts and stops the Trend Recorder collecting data for a real-time trend.
Reload DCA File Data causes data to be re-read from a .dca file.
Previous Trend displays previously recorded data.
Rewind moves the current event back through the currently displayed trend by one-
third of the currently displayed width of the time axis.