GE Industrial Solutions A-Series II Panelboards TQD - Manual (Page 4)

DEH40152
DEH40152 Rev.No.02 4
Figure 3. Attaching the shield insert to the shield for TQD breaker installation in
A-Series
®
II Panelboards.
12. If TQD breaker has to be installed after SG or SF/TFJ as shown in Figure 4 then
gap between the breakers (dim A) has to be followed as mentioned in Table 2.
Replace the subsequent blank filler of dead front with TQD filler plate given in kit
ASPP6QD6D using steps 9 to 11.
13. If TQD breaker has to installed immediate after crossbar as shown in Figure 5
then gap between the breaker and crossbar has to be 0.0525inch.