GE Industrial Solutions Spectra Series ACT Transient-Voltage User Manual
Page 4
7. Install the disconnect handle.
Mount the disconnect
handle as shown in Figure 11. The base of the handle
must be oriented so that the
OFF
indicator is on top
and the
ON
indicator is on the right. The handle
must be pointing down. Cover selection ([3], [4], or
[5]) is dependent on the width of the panelboard or
switchboard.
Figure 11. Handle from disconnect installed onto cover.
8. Mount the filler plate assembly
to the filler supports,
as shown in Figure 12. Secure with four 10-32 x
7
/
16
"
thread-forming screws [11] and tighten to 22 in.-lb.
Figure 12. Mounting the filler plate assembly on the supports.
g
GE Industrial Systems
General Electric Company
41 Woodford Ave., Plainville, CT 06062
DEH40443 R02 1001
© 2001 General Electric Company
These instructions do not cover all details or variations in equipment nor do they provide for every possible contingency that
may be met in connection with installation, operation, or maintenance. Should further information be desired or should
particular problems arise that are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the
GE Company.
Screws
from [8]
Handle
from [8]