GE Industrial Solutions Spectra Series Power Panelboards AEG 10, 21, 21S, 31S - Manual

g
Spectra Series™ Power Panelboards
Equipment Grounds, Types AEG 10, 21, 21S, 31S
Installation
WARNING: Danger of electrical shock or injury.
Turn OFF power ahead of the panelboard or
switchboard before working inside the
equipment or removing any component
.
Equipment is to be installed and maintained by
properly trained and qualified personnel only.
See Figures 1 and 2 for illustrations of AEG10 and AEG21
uninsulated equipment grounds and Figures 3 and 4 for
illustrations of AEG21S and AEG31S insulated equipment
grounds.
1. Attach terminals to the straps as shown in the
appropriate figure. Find the holes for mounting the
equipment ground at the opposite end of the box
from where it is stamped
Line . If the box is painted,
scratch through the paint in the area where the strap
is to contact the box. Mount the equipment ground
with the two 10-32 thread-forming screws provided
and tighten to 25-30 in-lb.
2. Remove the paper backing from the identification
label provided. Place the label below the equipment
ground, approximately in the position shown.
Figure 1. Equipment ground catalog number AEG10.
Figure 2. Equipment ground catalog number AEG21.
Figure 3. Equipment ground catalog number AEG21S.
GEH5586 Installation Instructions R02
Mounting
Positions
Identification
Labels
Mounting
Positions
Identification
Labels
Mounting
Positions
Identification
Labels