GE Industrial Solutions QS873A Thermal Probe Kit User Manual
Page 2
Doc ID:
CC848817445-MAN
2 OF 3
3/31/2008
Doc Type:
General Manual
11:14:34 AM
Doc Issue:
See change history above
Lineage Power
Proprietary - Use Pursuant To Company Instructions
4. Plug the end of the wireset from the expansion kit into the only available connector on the existing Thermal Probe as shown in
Figure 2 then snap case closed. The wires should then be cable tied back to the case for strain relief.
FIGURE 2: Daisy Chaining from Probe to Probe
5. If it was removed in step 2, reattach the existing thermal probe to its original battery. For details on how to mount to battery
see steps 7 & 8.
6. Before installing the new batteries, route the Wireset through the cabinet to the battery where the new Thermal Probe will be
connected. Use the upper left square hole as shown in the upper right view (Side 2) in Figure 3.
FIGURE 3: Thermal Probe Wireset Routing