GC EUROPE Unifil Bond - Manual (Page 23)

GC UniFil Bond Technical manual version 1.10, November 2005,
23/23
2) Take care not to mix with SELF-ETCHING PRIMER.
3) After dispensing, protect from light and use as
quickly as possible.
4) Replace bottle cap immediately after use.
5) Prior to blowing gentle air, make sure that no water or oil is injected from the
air syringe as this can adversely affect bonding effectiveness.
6) Be sure to use UniFil ® Bond Self-etching Primer with Bonding Agent. Do not
use other primers.
5. LIGHT CURING OF BONDING AGENT
Light cure for 10 seconds using a visible light curing unit (470nm wavelength)*.
In case of deep cavities, light cure for a minimum of 20 seconds.
*Irradiation time by light curing device
Halogen
(GC, Co-bee or Coe Lunar TA) 10 sec.
Plasma arc (GC Flipo) 3 sec.
Note:
When light curing material, wear eye protection glasses.
6. PLACEMENT OF LIGHT-CURED COMPOSITE
For placement of light-cured composite, follow manufacturer’s instructions for use.
STORAGE
Store in a refrigerator (2-8°C/35.6-46.4°F) when not in use.
(Shelf life: 2 years from date of manufacture)
CAUTION
1. UniFil
® Bond SELF-ETCHING PRIMER is flammable. Do not use near naked flame.
Keep away from sources of ignition. Keep away from sunlight. Use in a well
ventilated place.
2. In case of contact of UniFil ® Bond SELF-ETCHING PRIMER and BONDING AGENT
with oral tissues or skin, immediately remove with a sponge or cotton. Flush with
water. Note that the primer affected part may turn white. In this situation,
instruct the patient to leave undisturbed until the mark disappears in 2-3 days.
3. In case of contact with eyes, flush immediately with water and seek medical
attention.
4. Take special care that the patient should not swallow the PRIMER or BONDING
agent.
5. Do not mix with other similar products.
6. Do not use with chemically cured composite resins.