Net Optics GigaBit Fiber SFP Port Aggregator Tap - Manual (Page 12)

GigaBit Fiber Port Aggregator Tap
8
Changing the SFP Monitor Port Connector
You have the option to change the interface on the Monitor Port by changing
the small form-factor plug (SFP) on the Monitor Port . You can order conver-
sion kits which include the singlemode fiber, multimode fiber, GigaBit copper
SFP and appropriate cable from Net Optics . For ordering information, see
Specifications on page 9.
To change the SFP:
1 . Remove the cable from the SFP on the Port Aggregator Tap .
2 . Lower the wire clip to release the SFP connector .
3 . With the clip on the lowered position, pull gently on the clip to free the
SFP .
4 . Insert the new SFP until you hear it click into place .
5 . Connect the cable supplied with the kit .
Connecting Power
The second power supply is available to support the flow of traffic to the
monitoring device, in the event that the first power supply becomes unavail-
able. If the first power supply is unavailable, the second power supply will
supply all power for the Tap . Even if no power is available to the passive Tap,
network traffic flows uninterrupted.
1 . Supply power to the Tap via the two power connectors on the rear of the
unit . Two power supplies are included with the AC power models . The use
of the second redundant power supply is optional .
2. Verify that the Power LEDs illuminate. PWR 1 illuminates when the first
power supply is in use, and PWR 2 illuminates when the second power
supply is in use . Both power supplies can be plugged into the Tap at the
same time .