Asus F1A55-M LX PLUS - Manual (Page 35)

4. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you
can create a RAID 0, RAID 1, RAID 10, or JBOD configuration through the onboard
controller.
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows ® XP Service Pack 3 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
SATA3G_1
GN
D
RSATA_TXP1 RSATA_TXN1
GN
D
RSATA_RXN1 RSATA_RXP1
GN
D
SATA3G_2
GN
D
RSATA_TXP2 RSATA_TXN2
GN
D
RSATA_RXN2 RSATA_RXP2
GN
D
SATA3G_3
GN
D
RSATA_TXP3 RSATA_TXN
3
GN
D
RSATA_RXN3 RSATA_RXP3
GN
D
SATA3G_5
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXN5
RSATA_RXP5
GND
SATA3G_6
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXN6
RSATA_RXP6
GND
SATA3G_4
GN
D
RSATA_TXP
4
RSATA_TXN4
GN
D
RSATA_RXN4 RSATA_RXP4
GN
D
F1A55-M LX PLUS
F1A55-M LX PLUS SATA 3.0Gb/s connectors
ASUS F1A55-M LX Series 1-23