Reinstalling the storage drive assembly, Installing the foot stand – Asus P1-PH1 User Manual
Page 7
7
7
7
7
7
Q u i c k i n s t a l l a t i o n g u i d e
Q u i c k i n s t a l l a t i o n g u i d e
Q u i c k i n s t a l l a t i o n g u i d e
Q u i c k i n s t a l l a t i o n g u i d e
Q u i c k i n s t a l l a t i o n g u i d e
English
Reinstalling the storage drive assembly
Before reinstalling the storage drive assembly, connect the IDE and power
plugs to the IDE and power connectors at the back of the drives.
1.
Connect the black plug of the IDE cable to the optical drive, then the
gray plug to the hard disk drive.
2.
Connect the 4-pin power plugs to the power connectors at the back
of the drives.
3.
Install the storage drive assembly to the chassis.
4.
Secure the storage drive assembly with three screws.
3
3
3
3
3
4
4
4
4
4
1.
Match the foot stand hooks to
the holes on the chassis.
Installing the foot stand
2.
Pull the foot stand to the
direction of the arrow until the
lock clicks in place.
To remove the foot stand, lift the lock, then slightly push the foot stand to
the direction of the rear panel until it disengages from the chassis.