Asus P5GZ-MX - Manual (Page 45)

ASUS P5GZ-MX 1-33
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
9. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module
that supports either HD Audio or legacy AC’97 audio standard.
• We recommend that you connect a high-definition front panel
audio module to this connector to avail of the motherboard’s high-
definition audio capability.
• By default, this connector is set to AC97 Audio. If you want to
connect a High Definition front panel audio module to this connector,
set the Front Panel Support Type item in the BIOS to [HD Audio].
See section “2.4.6 Onboard Device Configuration” for details.
P5GZ-MX Front Panel Audio Connector
P5GZ-MX
R
HP_HD
MIC2_
L
HP_R HP_
L
MIC2_JD
Jack_Sense
MIC2_R
PRESENSE# AGND
AAFP
Legacy AC’97-compliant
pin definition
NC
MIC2_L
Line out_R Line out_L
NC
NC
MIC2_R
NC AGND
Azalia-compliant
pin definition
P5GZ-MX Intrusion Connector
P5GZ-MX
R
CHASSIS
+5VSB_MB Chassis Signal GND
(Default)