Asus P5PE-VM User Manual
Page 37
ASUS P5PE-VM
1-25
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA
100/66/33
IDE
devices.
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
These connectors are for Ultra DMA 100/66/33 signal cables.
There are three interfaces on each Ultra DMA 100/66/33 signal
cables: blue, black, and gray. Connect the blue interface into the
motherboad’s IDE connector, then select the following modes to
configure your hard disk drive(s).
Single device Cable-select or Master -
Black
Two devices Cable-select Master
Black
Slave
Gray
Master
Master
Black or gray
Slave
Slave
Drive Jumper Setting Mode of Devices Cable Connector
If any device jumper is set to “Cable-select”, make sure all other device
jumpers have the same setting.
R
P5PE-VM
P5PE-VM IDE Connectors
SEC_ID
E
PRI_ID
E