Asus GigaX2124X/C - Manual (Page 52)

GigaX Series L2 Managed Switch User’s Guide
52
4.6.3 Trap Setting
By setting trap destination IP addresses and community names, you can
enable SNMP trap function to send trap packets in different versions(v1 or v2c).
Click to save the configuration permanently or to
refresh the page.
Figure 30. Trap Setting
4.6.4 VACM Group
VACM(View-based Access Control Model) Group is used to configure the
information of SNMPV3 VACM Group
.
Group Name: enter the security group name.
Read View Name: enter the Read View Name that the Group belongs.
The related SNMP messages are Get,GetNext,GetBulk.
Write View Name: enter the Write View Name that the Group belongs.
The related SNMP message is Set.
Notify View Name: enter the Notify View Name that the Group belongs.
The related SNMP messages are Trap,Report..