Braun 7630 Syncro System Smart Logic - Manual (Page 7)

7
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. 7000. Available at
your dealer or Braun Service Centres.)
(* Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Preserving the cell unit
• In order to maintain the optimum capacity of the
rechargeable battery, the shaver has to be fully dis-
charged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity again.
This reconditions the rechargeable battery.
• Do not expose the shaver to temperatures of more than
50 °C for longer periods of time.
Accessories
Available at your dealer or Braun Service Centers:
• Braun Clean&Charge
• Shaver foil and cutter block (part No. 7000)
• Wall holder
Environmental notice
This appliance is provided with nickel-hydride recharge-
able batteries. To protect the environment, do not dis-
pose of the appliance in the household waste at the end
of its useful life. Open the housing as shown, remove
and dispose of the batteries at your retail store or at
appropriate collection sites according to national or
local regulations.
Subject to change without notice.
This product conforms to the EMC-Require-
ments as laid down by the Council Directive
89/336/EEC and to the Low Voltage Regulation
(73/23 EEC).
7000
7000
Syncro
7XXX
1 2
4
5 6
3
5493457_S 4-66 Seite 7 Donnerstag, 28. Februar 2002 2:45 14