Asus TS300-E6/PS4 - Manual (Page 45)

2-25 ASUS TS300-E6/PS4
2.8 Cable connections
2.8.1 Motherboard connections
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
Standard cables connected to the motherboard
1. 24-pin ATX power connector (from power supply to motherboard)
2. 8-pin 12V power connector (from power supply to motherboard)
3. System fan connector (from system fan to motherboard)
4. USB connector (from motherboard to front I/O board)
5. SATA conectors (system default; from motherboard to SATA/SAS backplane)
6. Chassis Intrusion connector (from rear chassis intrusion switch to motherboard)
7. System panel connector (from motherboard to front I/O board)
8. SAS connectors (for ASUS PIKE only; from motherboard to SATA/SAS backplane)
9. Serial General Purpose Input/Output connectors
(SATA: from motherboard SGPIO1 to SATA/SAS backplane SGPIO1 connector
SAS: from motherboard SGPIO2 to SATA/SAS backplane SGPIO2 connector
SAS: from motherboard SGPIO3 to SATA/SAS backplane SGPIO3 connector)
1
2
7
6
8
3
9
5
4
9