Asus AT3GC-I - Manual (Page 32)

2-9 ASUS AT3GC-I
Internal Graphics Mode Select [Enabled, 8MB]
Sets the internal graphics mode.
Configuration options: [Disabled] [Enabled, 1MB] [Enabled, 8MB]
DVMT Mode Select [DVMT Mode]
Allows you to select the graphics memory type.
Configuration options: [Fixed Mode] [DVMT Mode] [Combo Mode]
DVMT/FIXED Memory [128MB]
Configuration options: [64MB] [128MB] [Maximum DVMT]
2.4.4 Onboard Devices Configuration
HD Audio Controller [Enabled]
Enables or disables the Azalia/AC’97 CODEC. Configuration options: [Enabled] [Disabled]
Front Panel Support Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-definition audio depending on the audio standard that the front panel audio
module supports. Configuration options: [AC97] [HD Audio]
Onboard PCIEX LAN [Enabled]
Allows you to enable or disable the onboard PCIe 10/100 MB LAN controller.
Configuration options: [Enabled] [Disabled]
LAN Option ROM [Disabled]
Allows you to enable or disable the option ROM in the onboard LAN controller. This
item appears only when the Onboard LAN item is set to Enabled.
Configuration options: [Disabled] [Enabled]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4][2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Serial Port1 Mode [Normal]
Allows you to select the serial port1 mode.
Configuration options: [Normal] [IrDA] [ASK IR]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]
Parallel Port Mode [SPP]
Allows you to select the Parallel Port mode.
Configuration options: [SPP] [EPP] [ECP] [EPP+ECP]
The following item appears only when the Parallel Port Mode item is set to [ECP]
ECP Mode DMA Channel [DMA3]
Appears only when the Parallel Port Mode is set to [ECP]. This item allows you to
set the Parallel Port ECP DMA. Configuration options: [DMA0] [DMA1] [DMA3]
Parallel Port IRQ [IRQ7]
Configuration options: [IRQ5] [IRQ7]