Asus RS100-E4/PI2 - Manual (Page 32)

Chapter 2: Hardware setup 2-16
2. Locate the Serial ATA drive plate
under the optical disk drive (ODD)
bay.
SATA drive plate
3. Connect the Serial ATA signal cable
and ATX power connectors. Use
the L-type Serial ATA connector to
connect to the hard drive.
SATA L-type
connector
ATX power connector
SATA signal cable
4. Insert the Serial ATA drive into the
drive plate as shown.
To install secondary Serial ATA drive:
1. If you have an ODD installed,
remove the ODD bay first before
you install a secondary SATA disk
drive.
To remove, disconnect the ODD
cable and power cable then use
a screwdriver to remove all four
screws.