Asus P5KPL-AM SE - Manual (Page 53)

ASUS P5KPL-AM SE 2-15
C1É Support [Enabled]
Enable this item and users can configure the “Enhanced Halt State” function.
Configuration options: [Disabled] [Enabled]
Max CPUID Value Limit [Disabled]
Enable this item to boot legacy operating systems that cannot support CPUs with extended
CPUID functions. Configuration options: [Disabled] [Enabled]
Vanderpool Technology [Enabled]
Enable this item when the processor supports Vanderpool technology. Users need to reset
the computer to change the configuration of this item. Configuration options: [Disabled]
[Enabled]
CPU TM function [Enabled]
Enables or disables Intel® CPU Thermal Monitor (TM2) function, a CPU overheating
protection function. When enabled, the CPU core frequency and voltage is reduced when the
CPU is overheats. Configuration options: [Enabled] [Disabled]
Execute Disable Bit [Enabled]
Allows you to Enable/disable Execute Disable Function.
Configuration options: [Disabled] [Enabled]
Intel ® SpeedStep ® Technology [Enabled]
Allows you to use the Enhanced Intel ® SpeedStep ® Technology. When set to [Enabled], you
can adjust the system power settings in the operating system to use the EIST feature. Set
this item to [Disabled] if you do not want to use the EIST.
Configuration options: [Enabled] [Disabled]
2.4.4 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press <Enter> to display the sub-menu.
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI memory above the
total physical memory. Enable this option only when you install 64-bit operating system.
Configuration options: [Disabled] [Enabled]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configurating DRAM Timing by SPD.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
Internal Graphics Mode Select [Enabled, 8MB]
Allows you to select the amout of system memory used by the Interanal graphics device.
Configuration options: [Disabled] [Enabled, 1MB] [Enabled, 8MB]