Asus P8H77-M LE - Manual (Page 40)

1-30 Chapter 1: Product introduction
11. USB 3.0 connector (20-1 pin USB3_34)
This connector is for the additional USB 3.0 ports. Connect the USB 3.0 bracket cable
to this connector, then install the USB 3.0 bracket to the rear side of the chassis. If your
chassis support customized front panel installation, with ASUS USB 3.0 header, you
can have a front panel USB 3.0 solution.
• The USB 3.0 module is purchased separately.
• Due to Intel
® limitations, the USB3_34 only supports Windows ® 7 operating system.
10. Intel ® H77 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• These connectors are set to [IDE] by default. If you intend to create a Serial ATA RAID
set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].
See section 2.5.3 SATA Configuration for details.
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
folder named Manual in the support DVD.
• You must install Windows ® XP Service Pack 3 or later version before using Serial ATA
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI]. See section 2.5.3 SATA Configuration for details.
SATA6G_2
G
N
D
R
SATA
_R
XP
2
R
S
A
T
A
_R
XN
2
G
N
D
R
SA
TA
_TX
N
2
R
SATA
_TX
P
2
G
N
D
SATA6G_1
G
N
D
R
SATA_R
XP
1
R
S
A
T
A
_R
XN
1
G
N
D
R
SATA_T
X
N
1
R
SATA
_TX
P
1
G
N
D
P8H77-M LE
P8H77-M LE Intel ® SATA 6.0Gb/s connectors
P8H77-M LE
P8H77-M LE USB3.0 front panel connector
USB3_34