Asus DVD-E616P2 - Manual (Page 17)

ASUS DVD-E616P2 17
7. Device configuration jumper
These pins allow you to select either Master, Slave, or Cable Select
mode for the DVD-ROM device. (
Refer to page 18 for jumper settings.)
8. Host IDE in terface
This connector is for a 40-pin IDE cable to connect the drive to the IDE
interface on the motherboard.
9. DC input
This DC connector is for a 4-pin power cable from the system power supply.
Pin Name Switch Status Description
1 MA ON Master mode
2 SL ON Slave mode
3 CS ON Cable select mode
Pin Name Description
1 L Left channel audio output
2 & 3 G Ground
4 R Right channel audio output