Asus Vintage-AH1 - Manual (Page 40)

2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 A S U S V i n t a g e - A H 1 A S U S V i n t a g e - A H 1 A S U S V i n t a g e - A H 1 A S U S V i n t a g e - A H 1 A S U S V i n t a g e - A H 1
1
1
1
1
1
2
5
6
6
1 4
1 3
1 3
1 3
L o c k i n g L o c k i n g L o c k i n g L o c k i n g L o c k i n g
t a b h o l e
t a b h o l e t a b h o l e t a b h o l e t a b h o l e
2.11 Replacing the side plates and front
cover
After you have installed all the internal components and you have
connected all the necessary cables, you are now ready to put the system
back together.
1. Hook the hinge-like tabs to the holes on the right side of the front
panel to attach the front panel assembly to the chassis.
2. Swing the front panel inward.
H i n g e - l i k e t a b H i n g e - l i k e t a b H i n g e - l i k e t a b H i n g e - l i k e t a b H i n g e - l i k e t a b
3. Snap the side lock tabs to the steel railing.
4. Fit the rail tabs on the side plate into the locking tab holes in the
chassis.
5. Firmly push the side plate from the rear until it fits the chassis
completely.
The locking tabs snap into the hole on the chassis to indicate that the
side plate is in place.
6. Lock the side plate with the screws on the rear panel.
7. Repeat steps 4, 5, and 6 to replace the other side plate cover.
S i d e l o c k t a b S i d e l o c k t a b S i d e l o c k t a b S i d e l o c k t a b S i d e l o c k t a b
S t e e l r a i l i n g S t e e l r a i l i n g S t e e l r a i l i n g S t e e l r a i l i n g S t e e l r a i l i n g