Asus V2-PH2 - Manual (Page 83)

5-19 ASUS Vintage V2-PH2
5.4.2 JumperFree Configuration
Overclocking [Auto]
Allows selection of CPU overclocking options to achieve desired
CPU internal frequency. Select either one of the preset overclocking
configuration options:
Manual - allows you to individually set overclocking parameters.
Auto - loads the optimal settings for the system.
Configure System Frequency/Voltage
Overclocking [Auto]
Memory Clock Mode [Auto]
Select the target CPU
frequency, and the
relevant parameters
will be auto-adjusted.
Frequencies higher
than CPU manufacturer
recommends are not
guaranteed to be
stable. If the system
FSB/CPU External Frequency Synchronization
Front Side Bus CPU External Frequency
FSB 1066 266 MHz
FSB 800 200 MHz
FSB 533 133 MHz
The following item appears only when you set the Overclocking item to
[Manual].
CPU Frequency [XXX]
Displays the frequency sent by the clock generator to the system bus and
PCI bus. The value of this item is auto-detected by the BIOS. Use the <+>
and <-> keys to adjust the CPU frequency. You can also type the desired
CPU frequency using the numeric keypad. The values range from 100
to 400. Refer to the table below for the correct Front Side Bus and CPU
External Frequency settings.