En g lis h en g li sh en g lis h en g li sh, The tool menu – Asus CM6850 User Manual
Page 50
50
Chapter 6: Using the utilities
EN
G
LIS
H
EN
G
LI
SH
EN
G
LIS
H
EN
G
LI
SH
Launching EPU
EPU is an energy-efficient tool that provides you with a total power-saving solution. It detects
the current loading and intelligently adjusts the power usage in real-time. When you select
the Auto mode, the system changes modes automatically according to the current system
status. It allows you to customize each mode through configuring the settings such as CPU
frequency, vCore Voltage, and Fan Control.
To launch EPU:
•
Click
Tool > EPU on the AI Suite II main menu bar.
•
* Select From EPU Installation to show the CO that has been reduced since you
installed EPU.
•
* Select From the Last Reset to show the total CO that has been reduced since you
click the Clear button
.
*Shifts between the
display of Total and
Current CO2 reduced
Displays the system
properties of each mode
Displays the following message
if no �GA power saving engine is
detected.
Advanced settings for each mode
Multiple system
operating modes
Displays current mode
The items lighting up
means power saving
engine is activated
Displays the amount
of CO2 reduced
Displays the current
CPU power
Launching and configuring Probe II
Probe II is a utility that monitors the computer’s vital components, and detects and alerts you
of any problem with these components. Probe II senses fan rotations, CPU temperature,
and system voltages, among others. With this utility, you are assured that your computer is
always at a healthy operating condition.
To launch Probe II:
•
Click
Tool > Probe II on the AI Suite II main menu bar.
To configure Probe II:
•
Click the
�oltage/Temperature/Fan Speed tabs to activate the sensors or to adjust the
sensor threshold values.
•
The
Preference tab allows you to customize the time interval of sensor alerts, or
change the temperature unit.
Loads the default
threshold values
for each sensor
Applies your
changes
Loads your saved
configuration
Saves your
configuration
The Tool menu
The
Tool menu includes the EPU, Probe II, and Sensor Recorder panels.