Braun 7570 Syncro System - Manual (Page 9)

9
English
Our products are designed to meet the highest
standards of quality, functionality and design.
We hope you enjoy your new Braun shaver.
Your Braun Syncro is supplied with a
Braun Clean&Charge (please see separate
use instructions).
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 6 Switch
2 Shaver foil 7 Display
3 Cutter block 8 Info key
4 Foil release button 9 Pilot light
5 Long hair trimmer 10 Shaver socket
Technical specifications:
• Wattage via cord set: 7 W
• Power supply via cord set:
100-240 V 2 / 50 or 60 Hz (automatic adaptation)
• Shaver input voltage: 12-24 V
Charging the shaver
• First charging: Using the power supply cord set,
connect the shaver to the mains with the switch on
position «0» and charge it for at least 4 hours
(plug might get warm).
• Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging is
15 °C to 35 °C.
+35 °C
+15 °C
21
0
7570
5491458_S 4-78 Seite 9 Freitag, 7. April 2000 9:37 09