Asus P2L-B - Manual (Page 13)

ASUS P2L-B User’s Manual 13
III. INSTALLATION
Jumpers
1) CLRTC p. 15 Real Time Clock RAM (Clear Data)
2) KBPWR p. 15 Keyboard Power Up (Enable/Disable)
3) FS0, FS1, FS2 p. 16 CPU External Clock (BUS) Frequency Selection
4) BF0, BF1, BF2, BF3 p. 16 CPU:BUS Frequency Ratio
Expansion Slots
1) DIMM Sockets p. 17 168-Pin DIMM Memory Support
2) SEC CPU Slot p. 19 Single Edge Contact CPU Support
3) ISA Slot 1, 2 p. 24 16-bit ISA Bus Expansion Slots *
4) PCI Slot 1, 2, 3 p. 24 32-bit PCI Bus Expansion Slots
5) AGP p. 25 Accelerated Graphics Port
Hardware Monitor
1) RT2 p. 22 Pentium II Processor Thermal Sensor Connector
Connectors
1) KB p. 26 Keyboard Connector (5-pin Female)
2) FLOPPY p. 26 Floppy Drive Connector (34-1pins)
3) PRINTER p. 27 Parallel (Printer) Port Connector (26-1pins)
4) COM1, COM2 p. 27 Serial Port COM1 & COM2 (10-1pins)
5) IDE1, IDE2 p. 28 Primary / Secondary IDE Connector (40-1pins)
6) IDELED p. 28 IDE LED Activity Light (2 pins)
7) FAN p. 27 Power Supply, Chassis, CPU Fan Power Leads (3 pins)
8) W0L_CON p. 32 Wake on LAN Activity Connector (3-pins)
9) MSG.LED (PANEL) p. 30 System Message LED (2 pins)
10) SMI (PANEL) p. 30 SMI Switch Lead (2 pins)
11) PWR SW. (PANEL) p. 30 ATX Power & Soft-Off Switch Lead (2 pins)
12) RESET (PANEL) p. 30 Reset Switch Lead (2 pins)
13) PWR.LED (PANEL) p. 30 System Power LED Lead (3 pins)
14) KEYLOCK (PANEL) p. 30 Keyboard Lock Switch Lead (2 pins)
15) SPEAKER (PANEL) p. 30 Speaker Output Connector (4 pins)
16) USB/MIR p. 31 PS/2 Mouse/USB/IR Combo-Connector (18-1pins)
17) IR p. 31 Second Infrared Port Module Connector (5-pins)
18) ATX POWER p. 32 ATX Motherboard Power Connector (20-pins)
19) AT POWER p. 32 AT Motherboard Power Connector (12-pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address or else conflicts will occur.
(Map of Board)
III. INST
ALLA
TION