Asus M5A97/SI - Manual (Page 72)

3-20 Chapter 3: BIOS setup
Chapter 3
SB HD Azalia Configuration
Allows you to change the HD Azalia configuration.
[Enabled]
Enables the High Definition Audio Azalia device.
[Disabled] Disables the device.
The following two items appear only when you set the HD Audio Azalia Device item to
[Enabled].
Azalia Front Panel [HD]
Allows you to set the Azalia front panel audio connector (AAFP) type to legacy AC’97 or high-
definition audio depending on the audio standard that the front panel audio module supports.
[HD] Sets the front panel audio connector (AAFP) mode to high definition audio.
[AC97] Sets the front panel audio connector (AAFP) mode to legacy AC’97
SPDIF Out Type [SPDIF]
[SPDIF] Sets to [SPDIF] for SPDIF audio output.
[HDMI] Sets to [HDMI] for HDMI audio output.
3.5.7 APM
ErP Ready [Enabled]
Allows the BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When this item is set to [Enabled], all other PME options will be switched off. Configuration
options: [Enabled] [Disabled]
The following items appear only when you set the ErP Ready to [Disabled].
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.
Power On By PS/2 Device [Disabled]
Allows you to use PS/2 device to turn on the system. This feature requires an ATX power
supply that provides at least 1A on the +5VSB lead. Configuration options: [Disabled]
[Enabled]
Main Ai Tweaker Advanced Monitor Boot Tool
Exit
Allow BIOS to switch off some power
at S5 to get the system ready for Eup
requirement. When set to Enabled, all
other PME options will be switched off.
Back Advanced\ APM >
UEFI BIOS Utility - Advanced Mode
ErP Ready Enabled