Canon MultiPASS 10 - Manual (Page 10)

Canon MultiPASS 10 QRG ENGLISH
10
REDIALLING
1 Automatic Redialling
(58)
When a facsimile number is busy, does not answer, or an error occurs while sending, your fax waits for a short time and
then automatically redials the same number.
The fax displays REDIALLING while it is in the redialling process.
REDIALING
2 Manual Redialling
(58)
1 Press [REDIAL].
The number of the last party you
called is redialled.
RECEIVING DOCUMENTS
The fax is set up at the factory for receiving documents and telephone calls over one phone line (AUTO FAX/TEL switchover).
If the incoming call is from another fax, your fax will quietly receive the document without ringing. If the call is from a person,
your fax will ring to alert you to pick up the telephone and answer the call.
You can change this receiving mode to Automatic receiving or Manual receiving, as described in the Installation Guide.
1 Receiving Documents in the Memory
(70)
When the fax receives documents in memory, you see one of the following messages and you must perform one of the
following actions:
CHANGE CARTRIDGE Cause: You ran out of ink or the BJ cartridge is not set properly.
Action: Install a new BJ cartridge.
PUT IN CARTRIDGE Cause: There is no BJ cartridge.
Action: Install a BJ cartridge.
CHECK REC PAPER Cause: You ran out of recording paper.
Action: Load paper into the paper tray, then press [STOP].
REC. PAPER JAM Cause: A paper jam occurs.
Action: Clear the jam, then press [STOP].
CHK. FRONT COVER Cause: The front cover is open.
Action: Close the front cover.
The fax will automatically print out the contents of memory when you remedy the cause of the problem.
The numbers in parentheses indicate the page in the MultiPASS TM 10 INSTRUCTION BOOK on which you can find further details.
ቢͰĢĴ a a a a aaaaa a a a aaaaaaaaaaaa