Asus G1-P5G43 - Manual (Page 63)

ASUS G1-P5G43 5-9
LBA/Large.Mode.[Auto]
Enables or disables the LBA mode. Setting to [Auto] enables the LBA mode if the
device supports this mode, and if the device was not previously formatted with LBA
mode disabled. Configuration options: [Disabled] [Auto]
Block.(Multi-sector.Transfer).M.[Auto]
Enables or disables data multi-sectors transfers. When set to [Auto], the data
transfer from and to the device occurs multiple sectors at a time if the device
supports multi-sector transfer feature. When set to [Disabled], the data transfer
from and to the device occurs one sector at a time. Configuration options:
[Disabled] [Auto]
PIO.Mode.[Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA.Mode.[Auto]
Selects the DMA mode. Configuration options: [Auto]
SMART.Monitoring.[Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit.Data.Transfer.[Enabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled]
[Enabled]
5.3.4 Storage Configuration
The items in this menu allow you to set or change the configurations for the SATA
devices installed in the system. Select an item then press <Enter> if you want to
configure the item.
SATA Configuration [Enhanced]
Allows you to set the SATA configuration. Configuration options: [Disabled]
[Compatible] [Enhanced]
Configure SATA as [IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip. Configuration options: [IDE] [AHCI]