Asus Rampage II Extreme - Manual (Page 72)

TweakIt options
The following table shows TweakIt options. For detailed voltage and frequency
settings, refer to 3.3 Extreme Tweaker menu. For BIOS boot selection and
backup settings, refer to 3.7.3 BIOS Boot Priority and 3.8.4 BIOS Flashback.
Options Usages and Notes
1 HWINFO
1 VOLT
0 ALL
1 VTTCPU
2 VTTDDR
3 NB
4 CPUPLL
5 SB1_5V
6 SB1_1V
7 DDR
8 CPU
Selecting “0 ALL” shows all the values in a
continuous loop.
These values are automatically detected
and therefore are not configurable.
2 TEMP
0 ALL
1 OPT_1
2 OPT_2
3 OPT_3
4 POWER
5 NB
6 SB
7 MB
3 FAN
0 ALL
1 CPUFAN
2 PWRFAN
3 OPT_1
4 OPT_2
5 OPT_3
6 CHA_1
7 CHA_2
8 CHA_3
4 FREQ The value is shown in S0 state only.
2 DYNAOV
1 DDR
2 NB
3 VCORE
4 VTTCPU
5 CPUPLL
6 SB1_5V
7 SB1_1V
Move the SELECT joystick to adjust value
and then press CONFIRM.
These functions are available in S0 state
only.
3 DYNAOC FRQXXX
4 BIOS 1 BOOT SEL
1 BIOS1
2 BIOS2
Select which BIOS to boot (available in S5
state only).
*S0: System in the normal working state
* S5: System in the soft off state (power off with +5VSB power)
2-44 Chapter 2: Hardware information