Braun 130s-1-5683 Series 1 - Manual (Page 5)

5
• A full charge provides up to 20 minutes of cordless shaving time. This may vary
according to your beard growth.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
Shaving
Press the on switch (5) to operate the shaver.
To trim sideburns, moustache or beard, slide the long hair trimmer (4) upwards.
Tips for the perfect shave
For best shaving results, Braun recommends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Cleaning
The shaver head is suitable for cleaning under running tap water.
Warning: Detach the shaver from the power supply before cleaning the
shaver head in water.
Regular cleaning ensures better shaving performance. Rinsing the shaving head
under running water after each shave is an easy and fast way to keep it clean (A):
Model 150s only:
• Switch the shaver on and rinse the shaver head under hot running water.
• You may use liquid soap without abrasive substances. Rinse off all foam and let
the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil (2) and cutter block (3).
Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a drop of
light machine oil onto the long hair trimmer (4) and shaver foil.
Model 130s only:
• After each shave, rinse the shaver head under hot running water (A).
You may use liquid soap without abrasive substances. Rinse off all foam.
• Next, remove the shaver foil (2) and cutter block (3). Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using the brush provided (B):
• Switch off the shaver. Remove the shaver foil and tap it out on a flat surface.
• Using the brush, clean the cutter block and the inner area of the shaver head.
However, do not clean the shaver foil with the brush as this will damage the foil.
92270135_150s1_CEE_S4-54.indd 5 92270135_150s1_CEE_S4-54.indd 5 03.04.12 14:12 03.04.12 14:12