Asus V7-P5G41E - Manual (Page 46)

3-6 Chapter 3: Motherboard info
3. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There
are three connectors on each Ultra DMA 100/66 signal cable: blue, black, and
gray. Connect the blue connector to the motherboard’s IDE connector, then
select one of the following modes to configure your device.
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as “Cable-Select,” ensure that all other device
jumpers have the same setting.
Drive.jumper.setting Mode of
device(s)
Cable.connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master Black
Slave Gray
Master Master Black or gray
Slave Slave
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
PIN1
P5G41T-M LX2/GB
P5G41T-M LX2/GB IDE connector