Asus T3-P5945GCX2 - Manual (Page 68)

5-20 Chapter 5: BIOS setup
5.4.3 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
Advanced Chipset Settings
Configure DRAM Timing by SPD [Enabled]
DDR2 Memory Voltage [1.85V]
Graphic Adapter Priority [PCI Express/Int-VGA]
Internal Graphics Mode Select [Enabled,8MB]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configure DRAM timing by SPD.
Configuration options: [Disabled] [Enabled]
DDR2 Memory Voltage [1.85V]
Allows you to adjust the DDR2 memory voltage.
Configuration options: [1.85V] [1.90V] [1.95V] [2.00V]
Graphic Adapter Priority [PCI Express/Int-VGA]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [Internal VGA] [PCI Express/Int-VGA] [PCI Express/PCI]
[PCI/PCI Express] [PCI/Int-VGA]
Internal Graphics Mode Select [Enabled, 8MB]
Sets the internal graphics mode. Configuration options: [Disabled] [Enabled, 1MB]
[Enabled, 8MB]
Enable or disable
Configure DRAM Timing
by SPD
Intel ® SpeedStep(tm) Technology [Enabled]
Allows you to use the Enhanced Intel ® SpeedStep ® Technology. When set to
[Enabled], you can adjust the system power settings in the operating system to
use the EIST feature. Set this item to [Disabled] if you do not want to use the EIST.
Configuration options: [Enabled] [Disabled]
The following item appears only when you installed an Intel ® Pentium ® 4 or later
CPU that supports the Enhanced Intel SpeedStep ® Technology (EIST).