User’s manual, Troubleshooting – AIPTEK MobileCinema A50P User Manual
Page 13
User’s Manual
7
EN
Troubleshooting
Symptom
Check Point
The projector can not be turned
on.
Ensure the battery is fully charged.
The projecting image is too dark. * Use the Projector in a darker
environment.
* Decrease the size of projecting
image.
The projecting image is too
blurry.
Adjust the focus by using focus wheel.
The temperature of the
projector’s surface is warm.
It is normal that this projector to generate
moderate heat during operation.
The projector can’t project from
or charge MHL devices
MHL supported product list can be found:
http://www.mhlconsortium.org/productlist/
It’s not a guarantee to 100% compatible
as the MHL interface design may vary by
each mobile device vendor. It’s
recommended to check the compatibility.
The projector cannot be
charged.
Please check if the projector’s 3 LED
indicators are in Marquee. If not and they
are blinking, please press charging mode
button again to exit the charging mode
for MHL device.
The projector is turned on, but
the video can not be projected.
Please check your device if it supports
MHL or HDMI interface. If yes, please
check the source resolution of your
device output. Please refer the
supporting resolution to Appendix 1 and
modify your device output resolution.