Air Suspension Coil Spring Conversion LINCOLN Town Car 1998-2002 - Manual (Page 4)

8.
Remove the nut from the bottom of the shock. (Remove both sides)
9. Unhook the shock from the axle bracket. (Both sides) This will allow the rear axle to drop down a
few inches.
10. Place the top of the coil spring into the frame seat. (Push the wires and hose back)
11. Tie the wires and hose around the top of the coil spring. This will prevent the wires from touching
the exhaust or any moving parts. (Note: Do not cut the wires. Leave the system whole incase you ever
want to put the air suspension back on the vehicle.)
12. Pull down on the axle and push the coil spring on the axle seat.
13. Jack the axle up and replace the shock bolts. Tighten nuts.
14. Replace the wheels and lower the vehicles suspension.
15. To turn the light off and disable the air suspension, you must unhook the air suspension module.
The module is located in the luggage compartment, behind the air suspension switch. Pull back the wall
carpet and remove the 2 nuts that hold the suspension module. Unplug the suspension module and bolt
the module back in place. (Do not remove module from vehicle. Leave in vehicle incase you want to put
air suspension back on your vehicle.)
If you have any questions, please contact your dealer for assistance.