Analytical Industries GPR-2500 S Oxygen Analyzer - Manual (Page 39)

39
Fire and Explosion Data
Flash and Fire Points
Not applicable
Flammable Limits Not flammable
Extinguishing Method Not applicable
Special Fire Fighting Procedures Not applicable
Unusual Fire and Explosion Hazards Not applicable
Reactivity Data
Stability Stable
Conditions Contributing to Instability
None
Incompatibility Avoid contact with strong bases
Hazardous Decomposition Products Emits toxic fumes when heated
Conditions to Avoid Heat
Spill or Leak
Steps if material is released
Sensor is packaged in a sealed protective plastic bag, check the sensor inside
for electrolyte leakage. If the sensor leaks inside the protective plastic bag or
inside the monitor sensor housing do not remove it without rubber or latex
gloves, safety glasses and a source of water. Flush or wipe all surfaces
repeatedly with water or wet paper towel. Use a fresh towel each time.
Waste Disposal Method In accordance with federal, state and local regulations for battery disposal.
Health Hazard Information
Primary Route(s) of Entry
Ingestion, eye and skin contact
Exposure Limits Acetic Acid - ACGIH TLV / OSHA PEL 10 ppm (TWA); Lead - OSHA PEL .05
mg/cubic meter
Effects of Exposure -
Ingestion Electrolyte could be harmful or fatal if swallowed; Oral LD50 (RAT) = 6620
mg/kg
Eye Electrolyte is corrosive and eye contact could result in permanent loss of
vision.
Skin Electrolyte is corrosive and skin contact could result in a chemical burn.
Inhalation Liquid inhalation is unlikely.
Symptoms Eye contact - burning sensation; Skin contact - burning sensation.
Medical Conditions Aggravated None
Carcinogenic Reference Data
NTP Annual Report on Carcinogens - not listed; LARC Monographs - not
listed; OSHA - not listed
Other Lead is listed as a chemical known to the State of California to cause birth
defects or other reproductive harm. Lead acetate formed as the sensor is
used is listed as a chemical known to the State of California to cause cancer.