AVSL 154.111 RP4 - Manual (Page 2)

154.111UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
The RP4 4 channel DMX relay pack has 4 DMX channels each with 2 IEC power outputs per channel. It
completely turns the power on and off saving energy and preserving the lifespan of your light effects. This is
ideal for use with LED light effects, which when used with traditional dimmer packs turn on and off randomly
with the pulsed voltage sent through the system.
Features

4 DMX channel output

Power ON/OFF for each channel

DIP switch DMX addressing

Wall mountable
Warning before use
This item is for Professional use only. Please take note of the following instructions before using this device.
• This unit must be earthed.
• Do not turn on the power until all connections are securely made.
• Always disconnect from the mains before replacing any fuse
• There are no user serviceable parts inside
Fuses
The RP4 can carry maximum overall load of 10 amps. Each channel can also carry a maximum overall load of 10 amps
but the unit is factory fitted with 10amps on each channel. These can be changed but the maximum overall load and
each channel load must not exceed 10 amps. You must be professionally qualified in order to carry this out.
Layout
1. IEC Power outputs (2 x IEC per channel)
2. Power on/off switch
3. DMX input XLRM
4. DMX loop output XLRF
5. Channel fuses
6. AC power inlet
7. DIP switch settings