AVSL 153.727 IP65 DIY LED TAPE KIT User Manual
Diy led tape kit, User manual
DIY LED Tape Kit User Manual
DIY LED TAPE KIT
User Manual
DIY LED TAPE KIT - SINGLE COLOUR
Introduction
:
Thank you for purchasing the Fluxia DIY LED Tape Kit.
LED tape is ideal for use on the underside of a counter tops, shelves, cupboards, around
window frames or in an alcove of a ceiling to name just a few examples.
Before starting please ensure that you have read this instruction leaflet carefully.
If you are unsure about anything please have this installed by a competent installer.
Blister Contents:
1 x 5m reel of LED tape
1 x Power supply with 3 region adaptors (UK, EU & Worldwide)
Possible Required tools: Scissors, Craft knife, Soldering iron and solder, 2 core DC wire and heat shrink tube.
Step 1: Preparation
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to dry before fitting the tape.
Unravel the tape and connect the power supply. Check that all the LEDs are functioning correctly and if there are any faults return to your retailer
without delay.
Step 2: Cutting
WARNING: Disconnect from the power supply before attempting any cutting.
Measure out each section and cut with sharp scissors at the marked 5cm intervals to achieve the perfect length. Do not discard any excess tape as
it can be easily reconnected and used again (see FIG 2).
Step 3: Fitting:
Example 1: Simple straight run.
Clear the area you wish to install the tape and remove the backing paper, exposing the adhesive tape. Push tape firmly onto the surface. It is
recommended to work on 50cm sections at a time in order to ensure a professional finish. When you reach the end of your installation cut at the
marked cutting point.
Example 2: Requires cutting:
The tape can be cut at highlighted 5cm intervals for a perfect fit.
FIG 1:
You may also reconnect the two pieces by soldering the connection points together (FIG 2). The tape has two tracks for the DC voltage with +
positive pole at the top and – negative pole at the bottom.
To reattach, use a craft knife to cut the Epoxy coating from the terminals.