AVSL 210.903 VIDEO AMPLIFIER/SPLITTER 4 CH - Manual (Page 2)

GB
4-channel video signal splitter for in-car use, to connect several monitors to one
source.
Safety Recommendations:
- Do not watch DVDs while driving a bus or a car.
- Do not expose the unit to high temperatures.
- Do not use the unit in a humid environment.
- Do not let any liquids enter the ventilation holes.
- Do not obstruct the ventilation holes. Ensure sufficient air flow.
- Do not open the units. Repairs should only be carried out by a qualified
technician.
- Warning!! The 12Vdc version cannot be plugged directly into a 24Vdc system.
Please use a 24/12Vdc inverter.
Plug the white connector into the B + GND socket. Connect the black wire to the
negative and the red wire to the positive battery terminal. Install the splitter as close
as possible to the source (DVD player) via the supplied mounting hardware.
Connect a video signal to the splitter via the “V-IN” RCA socket. Set the strength of
any output signal via the Video Level controls. To route the signal to an input of a
monitor, you need to connect a video cable (75 Ohms) fitted with RCA connectors
between one of the four output channels of the splitter and the input channel of a
monitor. The LED indicator lights up red when the splitter is powered.
Specifications:
Video input level: .................................... 2.0Vpp
Output level: .................................... 0.5~1.5Vpp
Output impedance: ......................................75Ω
Power supply: ........................................ 12 VDC
Dimensions (WxDxH): ............ 104 x 74 x 20mm
•
Specifications and design subject to changes without prior notice.