AVSL 153.720 LED EPOXY TAPE RGB COLOUR - Manual

LED EPOXY TAPE RGB COLOUR
USER GUIDE V4.0
Introduction:
Super-bright RGB LED tape which when connected to a controller can produce any colour of the rainbow. Supplied on 5m reel
with an adhesive back this tape is easy to setup and quick to install. Its low voltage supply and low power consumption
makes it suitable for a wide variety of applications from homes to vehicles and from shops to bars and nightclubs. The LEDs
will last up to 50,000 hours and are covered with an epoxy coating to protect the tape from general wear and tear as well as
being water resistant, making cleaning an easy task.
Features:
 Marked graduations to aid cutting to size
 Can be cut to desired length (5cm intervals)
 Compatible with RGB controllers: 153.741UK, 153.742UK & 153.748UK (not supplied)
 60 ultra bright LEDs per metre
 Available in 5 different colours
 Self-adhesive backing for easy installation
 Low voltage (12Vdc) and power consumption
 Flexible and lightweight
 Supplied with easy to use connection accessories
 Can extend beyond 5m easily with RGB Data repeater amplifier (153.750UK)
 IP65 rated
Before starting please ensure you read this instruction leaflet fully. We recommend this tape is installed by a fully qualified
installer.
Section 1:
The LED tape comes supplied on a 5m reel and has 60 LEDS per metre. Different lengths can be cut at 5cm intervals marked
on the upper side of the tape. These can be easily re-connected to suit various applications.
Supplied in the foil bag: Requires:
1 x 5m Reel of RGB LED tape The correct power supply for the Length
2 x 20cm Extension lead with 4 pin plug on either end Suitable RGB controller
3 x 4 Pin couplers Signal Data Repeater for long length installations
6 x End connectors
1 x 20cm heat shrink
The LED tape has a four wire DC track, three to carry the signal and power to each individual LED diode and the other to
complete the circuit and return the signal back.
Yellow wire +12V Return
Green wire Green signal
Red wire Red signal
Blue wire Blue signal
Each individual LED on the tape has three colour diodes mounted inside. They are the primary colours of Red, Green and
Blue. When set at different intensities the light mixes and can produce many different colours
The end of the LED tape is terminated by a 4 pin socket. When connecting the supplied wire between the controller and the
tape ensure the yellow wire is at the top.
Points to remember when using this tape
1) Only cut the tape at the highlighted 5cm intervals
3) The top track of the tape is the return pole
5) Ensure you connect the correct wires otherwise the tape will not work
6) Ensure that when soldering there are no short circuits
7) It is really important after soldering that you use the heat shrink provided to protect the connection