AVSL 153.705 LED EPOXY TAPE SINGLE COLOUR - Manual

LED EPOXY TAPE SINGLE COLOUR
USER GUIDE V4.0
Introduction:
Our range of single colour, super-bright LED tapes are supplied on 5m reels with a choice of 5 different colours, each with an
adhesive back. The tape is easy to setup and quick to install, the low voltage supply and low power consumption makes them
suitable for a wide variety of applications from homes to vehicles, from shops to bars and also nightclubs. The LEDs will last
up to 50,000 hours and are covered with an epoxy coating to protect the tape from general wear and tear as well as being
water resistant, this means cleaning an easy task.
Features:
 Marked lengths to aid cutting to size
 Can be cut to desired length (5cm intervals)
 60 ultra bright LEDs per metre
 Available in 5 different colours
 Self-adhesive backing for easy installation
 Low voltage (12Vdc) and low power consumption
 Flexible and lightweight
 Supplied with easy-to-use connection accessories
 IP65 rated for outdoor use.
Before starting please ensure you read this instruction leaflet fully. We recommend this tape is installed by a
fully qualified installer.
Section 1:
The LED tape comes supplied on a 5m reel and has 60 LEDS per metre. Different lengths can be cut at 5cm intervals marked
on the upper side of the tape. These can be easily re-connected to suit various applications.
Supplied in the foil bag are:
1 x 5m Reel of LED tape
1 x 10cm DC extension lead
1 x 20cm DC cable
1 x 20cm Black heat shrink tube
The following colours are available:
Item Number Colour
153.705UK RED
153.708UK GREEN
153.711UK BLUE
153.714UK YELLOW
153.717UK WHITE
153.706UK PINK
153.717UK WARM WHITE
The tape has a DC track, + positive pole at the top and – negative pole at the bottom. It can be cut at 5cm intervals which
are highlighted by the scissors symbol as shown below. DO NOT cut the tape at any other intervals as it will permanently
damage the tape and will result in malfunction.
At either side of the cutting points are the DC connectors. If you want to extend these a DC cable can be soldered to them in
order to connect more tape.