AVSL 154.152 WDMX-2 - Manual (Page 2)

154.152UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the WDMX-2 wireless DMX transceiver as part of your lighting control system.
This unit can be used as a transmitter for qtx wireless PAR lights or in pairs for a wireless link between
standard DMX512 lighting controllers and fixtures.
Unpacking
Your WDMX-2 should reach you in good condition and should be supplied with IEC mains lead(s) and a
short antenna (mini TNC connection).
If there are any signs of damage or items missing from the packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose any components to rain or moisture.
If liquids are spilled on the housing, disconnect mains and allow unit to dry out & have checked by qualified
personnel before further use.
Avoid any impact or extreme pressure to the housing.
No user serviceable parts inside - do not open the case.
Refer all servicing to qualified service personnel.
Placement
The transmitter and receiver should be positioned where there is minimal obstruction to radio transmission
and where convenient to connect with DMX controller(s) and lighting fixture(s).
One transmitter can serve a virtually unlimited number of receivers when set to the same ID within the
transmission range.
The housing should be secured in place and not suspended from signal or mains cables.
Safety
 Check for correct voltage and condition of IEC lead before connecting to power outlet
 Ensure DMX leads are good condition with no short connections or damaged plugs
 This unit must be earthed
Cleaning
 Use a soft dry or slightly damp to clean the casing.
 Do not use strong solvents for cleaning the unit