AVSL 160.565 SW-2 SNOW MACHINE User Manual
Page 3
160.565UK User Manual
Rear Panel
Setting up
The SW-2 requires snow fluid, which forms small foam drops to create the snow effect.
It is recommended to use qtx snow fluid for best results (160.578, 160.579)
A chart for recommended fluids is included further along in this document.
Unscrew the top cap of the fluid tank (removable) and fill with the selected snow fluid
The SW-2 can accommodate a complete 5 litre snow fluid refill if preferred
Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the bottle so that a
consistent flow of fluid is supplied to the machine
Connect the remote control to the 5-pin DIN connector on the rear panel (6)
Connect the IEC mains lead supplied to the rear mains inlet (5)
Remote control operation
1. DIP switches for DMX address setting
2. DMX input (3-pin XLRM)
3. DMX output (3-pin XLRF)
4. Power on/off rocker switch
5. Mains inlet (IEC male) and fuse holder
6. Remote control connection (5-pin DIN)
7. Fluid level indicator
8.
Snow output control – adjusts the amount of fluid delivered by the pump
9.
Snow effect indicator – illuminates when effect is activated
10. Power indicator – illuminates when mains power is switched on
11. Snow effect on/off rocker switch – switches the fan on or off