AVSL 151.691 Pinspot Par 36 - Manual (Page 4)

GB
Congratulations on the purchase of this SkyTec light effect.
Please read this manual carefully prior to using the unit.
Warning:
- Read the manual prior to using the unit.
- Keep the manual for further reference.
- Keep the packaging so that you can transport the unit in its original packaging in order to
avoid damage.
- The SkyTec light effect contains a modern halogen lamp of a high light intensity. Do not
look into the lamp. This might damage seriously your eyes.
- During use, these lamps get very hot. Therefore the light effect must be placed at least
50 cm away from inflammable materials such as curtains, books, etc. Make sure that the
housing cannot be touched by accident.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the light effect.
- Unplug the unit from the mains prior to repairs, maintenance and replacement of the
lamp.
- Never plug or unplug the unit with wet hands.
- Disconnect the unit from the mains prior to replacing the fuse.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified
technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit
into a mains outlet.
- Repairs and lamp replacement has to be carried out by a qualified technician.
- Only connect this unit to an earthed mains outlet of 230Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside
the housing. Please let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can
be a solid chain, a steel cable, etc. which has to be fastened separately from the
mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety
regulations/warnings must be fulfilled.
- Keep out of the reach of children.
Installing/replacing the lamps
Before replacing the lamp, unplug mains lead and let the lamp cool down. Please follow
the lamp manufacturer’s notes when installing.
- You need one 6V 30W Par 36 Lamp for installaion.
- Please remove the fixation ring by pressing it together.
- If replacing the lamp, remove the old lamp from the pinspot and loosen the wires.
- Loosen the screws on the new 6V 30W Par 36 lamp with an appropriate screwdriver.
- Connect the wires with the lamp using an appropriate screwdriver.
- Tighten the screws.
- Insert the lamp in the housing.
- Fix the lamp with the fixation ring.
Rigging
- Mount the Pinspot with the mounting-bracket to your trussing system using an
appropriate clamp. The hole in the mounting bracket has a diameter of 10mm.