AVSL 151.170 LED STARCLOTHS User Manual
Page 4
User Manual –LED Starcloth
4
5.
Caution :
For your safety, please kindly pay attention to all of the warnings below:
Always plug in the power plug last and disconnect from the mains, when
the device is not in use or before cleaning.
Do not install and operate the device in rain or extreme heat, moisture
or dusty environments.
This device is for indoor use only and in a dry environment.
Do not switch on immediately but wait until it reaches room
temperature if the device has been exposed to drastic temperature
fluctuations.
Do not shake the device and avoid brute force when installing or
operating.
Do not use the device during thunderstorms and please disconnect the
power.
Do not use solvents or aggressive detergent to clean the device. Use a
damp clean cloth to wipe away marks or a vacuum cleaner to remove
dust marks etc. Do not put in a washing machine.
Do not modify the device or the connected power cord without
authorization.
Do not stare into the light
The symbol
determines the minimum distance from lighted
objects. The minimum distance between light-output and the
illuminated surface must be more than 0.5m.
User Manual –LED Starcloth
5
6. Connect with power supply:
Use the plug to connect to the main power supply as following.
Line
Connection
International signal
Brown
Live
L
Blue
Neutral
N
Yellow /Green
Earth
E
7. Replacing fuse:
Disconnect from the main power supply first, then remove the fuse from the
IEC socket or fuse holder . Replace with a fuse of the correct rating as stated
on product label or user guide.
8. General maintenance:
To maintain optimum performance and minimize wear, you should clean the
cloth frequently. Usage and environment are contributing factors in
determining the life span. As a general rule you should clean at least twice a
month. Dust build-up reduces light output performance and can cause
overheating. This can lead to reduced life. Be sure to power off fixture before
conducting maintenance.
Unplug fixture from power. Use a vacuum or air compressor and a soft brush
to remove dust collected.