AVSL 153.303 MINI PARTY STROBE LIGHT - Manual (Page 3)

Layout
Operation
This mini party strobe light is supplied with 3 colour gel filters to offer the option of a
colour strobe effect. If any of these are required, attach the selected gel to the front
transparent cover. Without the gel, the strobe light will be white.
Position or mount the unit in the preferred manner and direct the transparent cover
toward the area where the strobe effect will be required. Adjust the angle by
loosening the screws at the side of the bracket.
Connect the mains lead to an appropriate socket, ensuring adequate lead length and
correct voltage. The strobe will immediately begin to flash.
Adjust the rate (speed) of flashing effect by turning the rotary knob on the rear of
the housing.
When not in use, disconnect the unit from the mains.
1. Transparent cover
2. Strobe tube
3. Moulded housing
4. U bracket
5. Speed control (rear)