AVSL 153.300 SBF15 User Manual
Page 2
153.300UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the SBF15 strobe/blinder/flood light as part of your lighting effects rig.
Please read these instructions in full to gain the best results from this item and avoid damage to the unit.
Unpacking
Your SBF15 should reach you in good condition and be supplied with appropriate mains lead(s) and dual
mounting bracket. If there are any signs of damage or items missing from the packaging, contact your
dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose any components to rain or moisture.
If liquids are spilled on the housing, disconnect mains and allow unit to dry out & have checked by
qualified personnel before further use. Avoid any impact or extreme pressure to the housing.
No user serviceable parts inside – Do not open the case – refer all servicing to qualified service personnel.
Safety
Check for correct voltage and condition of IEC lead before connecting to power outlet
Placement
Mount the unit to a lighting stand or ceiling using the integral dual bracket
If the unit is mounted at height, a drop cable should be attached for safety
If free-standing, the dual bracket can form a stand to be positioned on a stable, non-slip surface
Ensure adequate access to controls and connections
Cleaning
Use a soft dry or slightly damp cloth to clean the housing. Do not use strong solvents
For best results, clean the front aperture periodically with a dry, lint-free cloth
Panel Layout
1.
DMX in (3-pin XLR)
2.
LED display
3.
DMX out (3-pin XLR)
4.
Control panel (FUNC, UP, DOWN, ENT)
5.
Sound sensitivity control
6.
Internal microphone
7.
Safety eyebolt
8.
Mains inlet (IEC) and fuse holder